The Challenges to Swim Spa Covers

Swim Spas represent distinct difficulties when it pertains to covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same factors a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, getting rid of and changing the cover can be a lot harder.
Getting a brand-new swim spa is an interesting event in life. You’re eagerly anticipating the workout you’ll get from using it. Perhaps you’re a little relieved to have actually finally selected from the various models you looked at. At any rate, you most likely weren’t believing much about the cover you would use.
Usually, the cover that gets back with your new purchase will be a four area stiff foam filled cover that will split in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style defect. Integrated in obsolescence since as quickly as it is placed in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper will not make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are very small as they increase from the water surface area. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It takes place gradually and on a Swim Spa Cover which is made from individual areas, at differing speeds. So ultimately you’ll observe one or two of the sections are actually getting heavy. The bar lifters on the ends of the swim spa aren’t much help since you still need to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com came up with a different design for their Swim Spa Covers
Instead of using numerous foam panels to build Swim Spa Covers that will ultimately wind up in some garbage dump, they developed one that utilizes air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or fall apart at the seams either. So if you own a swim spa, and you plan to keep using it everyday, SpaCap.com has the cover for it.
If you’re not ready to purchase today, bookmark this website so you can find it once again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *